Knitting and Crochet Forum banner
  • Wondering how to use different site features? Please visit our FAQ. Still have questions? Post to our Community Help section for a speedy response.
1 - 2 of 2 Posts

·
Registered
Joined
·
99 Posts
Discussion Starter · #1 ·
When using my GC on my Brother 970 I need to take the magnets on the back of the GC and put in the plastic bar. Now I want to use the GC on my Knit King 940 and need to replace the magnets. Does it matter how they are put in? Each magnet has a light grey and dark gray square on them...does it matter how these are placed. I ask because it is mispatterning at the far left of the needle bed about 12 stitches. I have switched out needles and changed the needle retainer bar and that doesn't help so I thought it might be the magnets.

All ideas will be appreciated!!

Carol
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top Bottom