Knitting and Crochet Forum banner
  • Wondering how to use different site features? Please visit our FAQ. Still have questions? Post to our Community Help section for a speedy response.
1 - 2 of 2 Posts

·
Registered
Joined
·
31 Posts
Discussion Starter · #1 ·
Hello, I am having an issue using the punch card - I'm sure it is operator error, but can't figure out what I'm doing wrong. Followed the directions in the manual, but after running the carriage across one time to select the needles, when I try to knit the pattern, my sinker plate runs in to the needles. Any ideas on what I'm doing wrong?
 

·
Registered
Joined
·
31 Posts
Discussion Starter · #5 ·
Thank you for your responses, the machine has a new sponge bar, so I took the sinker plate off another one of my machines, and it worked beautifully! I believe the original sinker plate has a bend in it, preventing it from going under the needles and instead running into them!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top Bottom